Canon iR2030 Series Service Manual page 106

Chapter 2
5) Install the three clamps [1] on the back of the host machine.
6) Connect the cassette heater harness [2] to the connector (J1905) on the heater PCB unit, install the reuse band [3], and then pass the harness through the clamps
installed in step 5).
7) Install the edge saddle (small) [1].
8) Connect the heater harness [2] to the connector [3] (J1902) on the heater PCB unit, pass it through the attached edge saddle, and then connect it to the connector
[4] (J224) on the DC controller PCB. Put the harness in the guide.
9) Install the delivery tray.
- RS tightening screws (M3 x 8) 2pcs.
10) Install the upper-right cover.
- RS tightening screw (M3 x 8) 1pc.
11) Install the lower right cover.
- RS tightening screws (M3 x 8) 5pcs.
12) Install the upper-right cover.
- RS tightening screw (M3 x 8) 1pc.
13) Install the rear cover.
- RS tightening screws (M3 x 8) 4pcs.
14) Close the front cover of the host machine.
2-34
[2]
[3]
[1]
F-2-79
[3] [1]
F-2-80
When attaching the delivery tray, be careful not to damage the full
stack sensor and paper holders.
[2]
[4]