7500-XXX
Parallel Strobe Adjustment (Par S Strobe Adj)
This setting enables you to adjust the amount of time the strobe is sampled in order to determine if valid data is
available on the parallel port. Each time this value is incremented by 1, the strobe is sampled 50 ns longer. Each
time this value is decreased by 1, the strobe is sampled 50 ns less. When the value of this setting is 0, the
factory default value is used to determine the length of time the strobe is sampled.
If you increases the value of this setting from 0 to 3, then the strobe will be sampled for 150 ns more than the
factory default value. Or, if you reduced the value of this setting from 0 to -1, then the strobe will be sampled for
50 ns less than the factory default value.
EVENT LOG
The exact number of events recorded in the Event Log will vary since each event requires a different amount of
storage space. When the Event Log requires more space to record an event, it overwrites the oldest currently
logged event(s) and inserts the new event into the first log position. Consecutive log entries may be identical if
the same event occurred twice in a row.
The Event Log records the following types of events:
•
All 9xx Service Errors
•
2xx Paper Jams
•
Maintenance Count Resets
•
NV Resets
•
JFFS2 Partition Format (Security Files)
•
JFFS2 Partition Format (BookmarkMgrData)
Touch EVENT LOG from the Diagnostics Menu, and the following options are displayed:
Display Log
Print Log
Clear Log
Display the Event Log
Note: The displayed version of the Event Log shows only a subset of the information contained in the
Diagnostics version of the printed Event Log. For the most comprehensive information about each logged event,
print the Event Log. See
3-22
MFP Service Manual
"Print the Event Log" on page
3-24.