Sensor (Lower Media Exit) Off Jam A - Lexmark X850e Service Manual

7500-XXX

284.00 Sensor (lower media exit) off jam A.

Step Check
1 Check the media path.
Open the finisher front door assembly. Check the lower
media exit roll assembly by turning it with your fingers.
Is the lower media exit roll assembly installed properly?
2 Is the lower media exit roll assembly free of damage?
3 Check the sensor (lower media exit) for proper
operation.
Perform the sensor (lower media exit) test.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 1.
5. Touch Lower media exit.
Open the finisher front door.
Move the lower media guide assembly to the right.
Push a sheet of media into the paper path towards the
sensor (lower media exit).
Does the operator panel display change every time the
actuator of the sensor (lower media exit) is operated?
4 Check the sensor (lower media exit) connection.
Is the above sensor connected properly?
5 Check the drive motor (exit) for proper operation.
Perform the drive motor (exit) test.
Remove the finisher rear upper cover. Go to
upper cover removal" on page
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Motor Tests.
4. Touch Motor (exit).
Does the motor (exit) operate properly?
6 Check the drive motor (exit) connection.
Is the above motor connected properly?
2-80
Options Service Manual
Yes
Go to step 2.
Go to step 3.
Go to step 5.
Replace the
sensor (lower
media exit).
Go to
(lower media
exit) removal"
on page
Go to step 7.
"Rear
4-101.
Replace the drive
motor (exit).
Go to
motor (exit)
assembly and
belt (exit)
removal" on
page 4-190
No
Clean or replace
the lower media
exit roll assembly,
and clean the
media path.
Clean or replace
the lower media
exit roll assembly,
and clean the
media path.
Go to step 4.
Replace the
connection.
"Sensor
4-157.
Go to step 6.
Replace the
connection.
"Drive