Sensor (Tray 2 Feed-Out) On Jam (Tray 4 Media Feed) - Lexmark X850e Service Manual

7500-XXX
Step Check
8 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 3.
5. Touch Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the operator panel display change every time the
actuator for the above sensor operates?
9 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
10 Perform a print test.
Does the error still occur?
11 Perform a print test.
Does the error still occur?

244.02 Sensor (tray 2 feed-out) on jam (tray 4 media feed)

Step Check
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media size setup.
Does the media size in use match the size set for
tray 4?
2-16
Options Service Manual
Yes No
Replace the sensor Go to step 9.
(tray 3 feed-out).
"2X 500-
Go to
sheet drawer
(2TM)–sensor
(tray 3 feed-out)
removal" on
page 4-37.
Go to step 10. Replace the
connection.
Replace the 2TM/ Problem solved.
TTM controller card
assembly.
"2X 500-
Go to
sheet drawer
(2TM)–2TM/TTM
controller card
assembly removal"
on page 4-43.
Go to step 11.
Replace the printer Problem solved.
engine card
assembly.
Refer to the Printer
Service Manual.
Yes No
Replace the media. Go to step 2.
Go to step 3. Replace the media
or change the media
size setup.