Sensor (Bridge Unit Media Entrance) Static Jam A - Lexmark X850e Service Manual

Step Check
6 Check the bridge unit drive motor connection.
Is the above motor properly connected?
7 Perform a print test.
Does the error still occur?
8 Perform a print test.
Does the error still occur?

280.01 Sensor (bridge unit media entrance) static jam A

Step Check
1 Perform the sensor (bridge unit media entrance) test.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 1.
5. Touch Bridge media ent.
Open the bridge unit top cover assembly.
Does the operator panel display change every time the
actuator of the sensor (bridge unit media entrance) is
operated?
2 Check the sensor (bridge unit media entrance)
connection
Is the above sensor connected properly?
Yes No
Replace the Replace the
bridge unit drive connection.
motor.
Go to "Bridge
unit drive motor
assembly
removal" on
page 4-90.
Replace the Problem solved.
bridge unit
interface card
assembly.
Go to "Bridge
unit interface
card assembly
removal" on
page 4-194.
Go to step 8.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-195.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
sensor (bridge connection.
unit media
entrance).
"Sensor
Go to
(bridge unit
media entrance)
removal" on
page 4-93.
Diagnostic information
7500-XXX
2-59