[Center Staple Position] - Konica Minolta bizhub C554 User Manual

17
Settings
[Horizontal Punch (Z-Fold)
Position Adjustment]
[1st Z-Fold Position Adjust-
ment]
[2nd Z-Fold Position Ad-
justment]
[Punch Unit Size Detect
Sensor]
[Post Inserter Tray Size Ad-
justment]
[Paper Alignment Plate
Settings]

[Center Staple Position]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Center Staple Position]
If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple posi-
tion on the fold.
Copy after configuration, then repeat adjustments as required.
Settings
[Paper Size]
[Adjust Value]
Tips
- This item is available when the Finisher FS-534 and Saddle Stitcher SD-511 are installed.
- This item is available when the Finisher FS-535 and Saddle Stitcher SD-512 are installed (only for
bizhub C554).
- Adjust the half-fold position before adjusting the center staple position.
- Make adjustment while checking paper stapled at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
- For adjustments to put staples parallel with the left edge of paper, contact your service representative
for instructions.
17-18
Description
If the positions of the punch holes on the paper are displaced sideways,
use this option to adjust the punch hole positions.
For details, refer to page 17-24.
Use this option to adjust the 1st Z-fold position.
For details, refer to page 17-25.
Use this option to adjust the 2nd Z-fold position.
For details, refer to page 17-25.
Use this option to adjust the sensor of the Punch function to detect the
edge of the paper.
For details, refer to page 17-26.
If the size of the paper loaded into the post inserter is not detected correct-
ly, use this option to automatically adjust it so that it is detected correctly.
For details, refer to page 17-26.
If paper is not discharged with the edges aligned, use this option to adjust
the effective width of the paper alignment plate for making discharged pa-
per stored neatly.
For details, refer to page 17-26.
Description
Select the size of paper that is used to adjust the staple position.
Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the staple position to the left.
• [+]: Move the staple position to the right.
[0.0 mm] is specified by default.
bizhub C554/C454/C364/C284/C224