[Printer Adjustment]; [Leading Edge Adjustment] - Konica Minolta bizhub C554 User Manual

17

[Printer Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Printer Adjustment]
Adjust the print start position and defective print images.
Settings

[Leading Edge Adjustment]

[Centering]
[Leading Edge Adjustment
(Duplex Side 2)]
[Centering (Duplex 2nd
Side)]
[Erase Leading Edge]
[Vertical Adjustment]
[Media Adjustment]
[Leading Edge Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Printer Adjustment]
- [Leading Edge Adjustment]
Adjust the print start position at the leading edge of the paper relative to the paper discharge direction.
Press Start to print a test pattern. Check the test pattern and adjust so that the margin between the leading
edge of the paper and the print start position is 3/16 inches (4.2 mm). Repeat adjustments, as required.
Settings
[Paper Type]
[Adjust Value]
17-14
Description
Adjust the print start position at the leading edge of the paper relative to
the paper discharge direction.
For details, refer to page 17-14.
Adjust the print start position on the left edge of the paper relative to the
paper discharge direction.
For details, refer to page 17-15.
Adjust the print start position at the leading edge of the back side of the
paper relative to the paper discharge direction for printing the back side in
2-sided printing.
For details, refer to page 17-15.
Adjust the print start position at the left edge of the paper relative to the
paper discharge direction for printing the back side in 2-sided printing.
For details, refer to page 17-16.
Adjust leading edge erase width. For details, contact your service repre-
sentative.
Adjust the feed direction zoom ratio of paper types. For details, contact
your service representative.
Adjust print defects (voids, white spots, roughness) that are caused by pa-
per properties for each paper type.
For details, refer to page 17-17.
Description
Select the type of paper that is used to adjust the start position for printing.
Enter an adjustment value between -3.0 and +3.0 mm by tapping [-] and
[+].
[0.0 mm] is specified by default.
bizhub C554/C454/C364/C284/C224