Draytek Vigor2912 Series User Manual page 265

Always On
Server IP/Host Name
for VPN
IKE Authentication
Method
Digital Signature
(X.509)
IPsec Security
Method
User Name
Password
Remote Network IP
Remote Network
Mask
3. After finishing the configuration, please click Next. The confirmation page will be shown
as follows. If there is no problem, you can click one of the radio buttons listed on the page
and click Finish to execute the next action.
the only channel for VPN connection.
WAN1 Only: Backup WAN2/WAN2 Only: Backup
WAN1 - While connecting, the router will use
WAN1/WAN2 as the only channel for VPN connection. If
WAN1/WAN2 fails, the router will use backup
WAN2/backup WAN1 interface instead.
Check to enable router always keep VPN connection.
Type the IP address of the server or type the host name for
such VPN profile.
IKE Authentication Method usually applies to those are
remote dial-in user or node (LAN to LAN) which uses
dynamic IP address and IPsec-related VPN connections
such as L2TP over IPsec and IPsec tunnel.
Pre-Shared Key- Specify a key for IKE authentication.
Confirm Pre-Shared Key-Confirm the pre-shared key.
Click Digital Signature to invoke this function.
Peer ID – Choose the peer ID selection from the drop down
list.
Local ID – Choose Alternative Subject Name First or
Subject Name First.
Local Certificate – Use the drop down list to choose one of
the certificates for using. You have to configure one
certificate at least previously in Certificate Management
>> Local Certificate. Otherwise, the setting you choose
here will not be effective.
Medium - Authentication Header (AH) means data will be
authenticated, but not be encrypted. By default, this option
is active.
High - Encapsulating Security Payload (ESP) means
payload (data) will be encrypted and authenticated. You
may select encryption algorithm from Data Encryption
Standard (DES), Triple DES (3DES), and AES.
This field is used to authenticate for connection when you
select PPTP or L2TP with or without IPsec policy above.
The length of the use name is limited to 11 characters.
This field is used to authenticate for connection when you
select PPTP or L2TP with or without IPsec policy above.
The length of the password is limited to 11 characters.
Please type one LAN IP address (according to the real
location of the remote host) for building VPN connection.
Please type the network mask (according to the real location
of the remote host) for building VPN connection.
255 Vigor2912 Series User's Guide