Load-Balance Policy - Draytek Vigor2912 Series User Manual

4 . 1 . 5 L o a d - B a l a n
4 . 1 . 5 L o a d - B a l a n
This router supports the function of load balancing. It can assign traffic with protocol type, IP
address for specific host, a subnet of hosts, and port range to be allocated in WAN1, WAN2,
and WAN3 interface. The user can assign traffic category and force it to go to dedicate
network interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when WAN1, WAN2 and WAN3 are
activated.
Available settings are explained as follows:
Item
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
c e P o l i c y
c e P o l i c y
Description
Click the number of index to access into the load-balance
policy configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the
WAN interface.
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
Displays the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
121 Vigor2912 Series User's Guide