Centralized Group No. Setting - Daikin E-Series Service Manual

Field Setting for SkyAir Indoor Unit
4.6

Centralized Group No. Setting

" If carrying out centralized control with a central remote control and unified ON/OFF
" To set the group No., first turn on the power supply of the central remote control, unified ON/
Centralized 1. If the inspection/test button is pushed for 4 seconds or more when in the normal mode,
Group No. Setting
2. Using the temperature control buttons, set the mode No. to "00."
by Remote
3. Push the inspection/test button to inspect the group No. display.
Control
4. Using the programming time button, set the group No. for each group. (Group No. rises in
5. Push the timer ON/OFF button and enter the selected group No.
6. Push the inspection/test button and return to the normal mode.
∗ If the address has to be set individually for each unit for power consumption counting, etc., set
the mode No. to "30."
Group No. Setting
Example
Note: 1. "F1,F2" indicates interface adapter for SkyAir series.
2. If not using remote controls, temporarily connect a remote control to set the group No., set
144
controller, you have to set the group No. for each group by remote control.
OFF controller and indoor unit.
operation enters the "field set mode."
the order of 1-00, 1-01, ...1-15, 2-00 ...4-15, etc. The unified ON/OFF controller however
displays only the range of group numbers selected by the switch for setting each address.)
Group No.
Central remote control
Unified ON/OFF controller
the group No. for centralized control, and then disconnect the controller.
Indoor unit
Group No. for
centralized
control
No remote control
Remote control centralized control
(automatic address)
SiENBE18-621
Mode No.
Field
set
mode
Test Operation