To Set The Clock - Daikin E-Series Service Manual

SiENBE18-621

" To set the clock

1. Press "CLOCK button".
2. Press "TIMER setting button" to set the
3. Press "CLOCK button".
" Turn the breaker ON
•
NOTE
" Tips for saving energy
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps to save energy.
• Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them once in about every two weeks.
" Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Mode
COOL
HEAT
DRY
• Operation outside this humidity or temperature range may cause a safety device to disable the system.
System Configuration
0:00 is displayed.
blinks.
clock to the present time.
Holding down " " or "
increases or decreases the time display.
:
blinks.
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
Operating conditions
Outdoor temperature <2MK(X)S40 10 to 46°C
<2MXS52> –10 to 46°C
<3/4/5MK(X)S> –10 to 46°Cá
<RK(X)S –10> to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
Outdoor temperature <2MXS40> –10 to 15.5°C
<2MXS52> –15 to 15.5°C
<3/4/5MXS> –15 to 15.5°C
<RXS20/25/35> –15 to 20°C
<RXS50> –15 to 18°C
Indoor temperature: 18 to 32°C
Outdoor temperature: <2MK(X)S40W 10 to 46°C
<2MXS52W –10 to 46°C
<3/4/5MK(X)SW –10 to 46°C
<RK(X)S> –10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
" button rapidly
If operation is continued out of this range
• A safety device may work to stop the operation.
(In multi system, it may work to stop the
operation of the outdoor unit only.)
• Condensation may occur on the indoor unit and
drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and
drip.
Instruction
Recommended temperature setting
For cooling:26°C – 28°C
For heating:20°C – 24°C
175