Instruction
FTK(X)S 20/25/35 C
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
UNITS
" Indoor unit, outdoor unit and remote control
1. Wipe them with dry soft cloth.
" Front panel
1. Open the front panel.
2. Remove the front panel.
3. Clean the front panel.
4. Attach the front panel.
CAUTION
•
Don't touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
•
After cleaning, make sure that the front panel is securely fixed.
206
•
Hold the panel by the tabs on the two sides
and lift it until it stops with a click.
•
Supporting the front panel with one hand,
release the lock by sliding down the knob
with the other hand.
•
To remove the front panel, pull it toward
yourself with both hands.
•
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
In case of washing the panel with water, dry
it with cloth, dry it up in the shade after
washing.
•
Set the 3 keys of the front panel into the slots
and push them in all the way.
•
Close the front panel slowly and push the
panel at the 3 points.
(1 on each side and 1 in the middle.)
•
Check to see if the rotating axis in the upper
center section is moving.
SiENBE18-621
Fit the key
into the slot.
System Configuration