Instruction
" To use ON TIMER operation
•
1. Press "ON TIMER button".
2. Press "TIMER Setting button" until the time
3. Press "ON TIMER button" again.
" To cancel ON TIMER operation
4. Press "CANCEL button".
" To combine ON TIMER and OFF TIMER
•
ATTENTION
" In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote control.
200
Check that the clock is correct. If not, set the
clock to the present time.
•
6:00 is displayed.
•
"
"blinks.
setting reaches the point you like.
•
Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
•
The TIMER lamp lights up..
•
The TIMER lamp goes off.
A sample setting for combining the two timers is
shown below.
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
Combined
ON TIMER at 7:00 a.m.
SiENBE18-621
System Configuration