Program; Registering Programs - Kyocera ECOSYS M3540dn Operation Manual

Sending Faxes > Program

Program

By registering sets of frequently used functions as a single program, you can simply press one of the

[Program

IV] keys as needed to recall those functions.
The following functions are already registered in
sides of ID card or other document that is smaller than Statement or A5 size onto a single page. Although the functions
are deleted by overwriting
• Paper Selection: Cassette 1
• Zoom: Auto
• Combine: 2 in 1
• Original Size: Statement (Inch models)/A5 (Metric models)
• Continuous Scan: On
[ID Card Copy] is printed on the
NOTE
It is possible to register the copy function, sending function and fax function in a program.
If user login administration is enabled, you can only register functions by logging in with administrator privileges.

Registering Programs

Use the procedure below to register a program.
1
[Program
[Program I] key, you can register the same settings using the
[Program I] key.
Configure the settings of the functions.
Configure the settings of the functions you want to register in a program.
For the settings of functions, refer to
NOTE
In the case of the sending function and fax function, a destination is also registered in the
program.
I] key. This function allows you to copy the front and back
Fax transmission functions on page
3-28
[Program I] to
[Function Menu] key.
3-19.