Installing Using The Data Control Function (Utility) - Mitsubishi GT16 User Manual

7.3.2

Installing using the data control function (Utility)

For details of data control function, refer to the following.
6. DATA CONTROL
POINT POINT POINT
Precautions on executing data control function
When execute data control function, standard monitor OS has to be installed in GOT in advance. Thus, this
function cannot be used for the initial installation of BootOS, standard monitor OS after purchasing GOT.
Install standard monitor OS by the following two methods.
(1) GT Designer3 or GT Designer2
(2) Installing when starting the GOT

Operation procedure
(1) When installing with CF card
1.
Power OFF the GOT. After CF card access LED is off, install the CF card in which BootOS, standard
monitor OS or project data is stored in the CF card interface of GOT.
2.
Switch ON the CF card access switch of GOT.
3.
Display the data control function screen (Utility) on the GOT, and install BootOS, standard monitor OS from
the CF card to GOT.
4.
CF card access LED is lit during install execution.
Do not pull out the CF card or power OFF the GOT while the CF card access card is lit.
7.3 BootOS and Standard Monitor OS Installation Using CF Card or USB Memory
Touch [Install]
1
2
3
4
5
6
7
7 - 7