Table of Contents
Advertisement
16.3.2 Installation method using the program/data control function (Utility)
For details of program/data control function, refer to the following.
Chapter 13 FILE DISPLAY AND COPY (PROGRAM/DATA CONTROL)
Program/data control is a function to install OS files from the CF card to GOT by the Utility operation.
Precautions on executing program/data control function
(1) Method using drawing software
(2) Installation method when turning the GOT power on
1
Operation procedure
Touch [Install].
When execute program/data control function, Standard monitor OS has to be
installed in GOT in advance. Thus, this function cannot be used for the initial
installation of Standard monitor OS after purchasing GOT.
Install Standard monitor OS by the following two methods.
GT Designer2 Version
GT Designer3 Version
Section 16.3.1 Installation method when the GOT is turned on
16.3 BootOS and Standard Monitor OS Installation Using CF Card
16.3.2 Installation method using the program/data control function (Utility)
Basic Operation/Data Transfer Manual
Screen Design Manual (Fundamentals)
1
Power OFF the GOT. After CF card access
LED is off, install the CF card in which
BootOS, Standard monitor OS or project
data is stored in the CF card interface of
GOT.
2
Switch ON the CF card access switch of
GOT.
3
Display the program/data control function
screen (Utility) on the GOT, and install
BootOS, Standard monitor OS from the CF
card to GOT.
9
10
11
12
13
14
15
16
16 - 6
Advertisement
Table of Contents
Troubleshooting
