I/O Check - Mitsubishi GT16 User Manual

5.1.7

I/O check


I/O check function
The I/O check is a function which checks whether GOT and PLC can communicate with each other.
If I/O check ends normally, the communication interface and the connection cable hardwares are normal.
To execute I/O check, the communication driver has to be installed in GOT in advance from GT Designer3 or GT
Designer2.
Note that the GOT restarts when this function is performed.
Refer to the following for the details related to the installation of the communication driver.
(1) Communication drivers inapplicable to I/O check
When the following communication drivers are used, the I/O check cannot be executed.
Connection type
MELSECNET/H
connection
MELSECNET/10
connection
CC-Link IE Controller
Connection to
Network connection
MITSUBISHI
PLC
CC-Link IE Field Network
connection
CC-Link connection
(Intelligent device station)
Ethernet connection
Connection to FUJI PLC
Connection to YASKAWA PLC
Connection to YOKOGAWA PLC
Connection to ALLEN-BRADLEY PLC
Connection to SIEMENS PLC
Microcomputer connection
Inverter connection

MODBUS /TCP connection
AZBIL control equipment connection
Connection to RKC temperature controller
5 - 15 5.1 Diagnostic Functions
• GT Designer3 Version1 Screen Design Manual (Fundamentals)
(7. COMMUNICATION WITH GOT)
• GT Designer2 Version
(8. TRANSFERRING DATA)
MELSECNET/H
MELSECNET/H
CC-Link IE Controller Network
CC-Link IE Field Network
CC-Link Ver.2(ID)
Ethernet(MELSEC), Q17nNC, CRnD-700
FUJI PXR/PXG/PXH
YASKAWA GL/CP9200(SH/H)/CP9300MS, Ethernet (YASKAWA)
YOKOGAWA FA500/FA-M3/STARDOM, Ethernet (YOKOGAWA)
EtherNet/IP(AB)
SIEMENS S7-200, SIEMENS S7-300/400, Ethernet(SIEMENS S7)
Computer
FREQROL 500/700/800, Sensorless servo
MODBUS/TCP
Azbil SDC/DMC
RKC SR Mini HG (MODBUS)
Basic Operation/Data Transfer Manual
Communication driver