Table of Contents
Advertisement
POINT
POINT
POINT
(1) When the utility call key is not specified
The followings are the method for displaying the utility without using the utility call key.
(a) Changing the project data in GT Designer3
1.
Read the project data in GT Designer3.
2.
Set either of the followings in GT Designer3.
• Set the utility call key in the [Display/Operation] tab of the [Environmental Setting] dialog box.
• Set a special function switch to display the utility at the user-created screen.
3.
Write the project data whose setting is changed to the GOT.
(b) Operating the forced start-up of the utility with the GOT
After powering on the GOT, pressing the S.MODE switch during [Booting] displayed on the upper left
displays the utility in the screen.
When restricting the display of the utility, set a password in GT Designer3.
•GT Designer3 Version1 Screen Design Manual (Fundamentals)
(4.7 Security Setting)
(2) Precautions on using the advanced alarm popup display
When [Display Position Switching] is set to [Switch] in the advanced alarm popup display setting, set either of
the following for the utility call key.
• Setting the position of the utility call key to the upper-right or lower-left corner
• Setting [Pressing Time] of the utility call key to 1 or more seconds
When [Pressing Time] is set to 0 and the key position is set to the lower-left corner, the operation is as
described below.
If the positions of the key and the advanced alarm popup display overlap, the utility screen appears by
switching the display position of the advanced alarm popup display.
For the advanced alarm popup display, refer to the following.
•GT Designer3 Version1 Screen Design Manual (Functions)
(10.8 Advanced Alarm Popup Display)
•GT Designer2 Version
(8.5 Advanced Alarm Popup Display)
Screen Design Manual
2.3 Operation Settings (Settings Regarding Operation)
1
2
3
4
5
6
7
2 - 57
Advertisement
Table of Contents
