Table of Contents
Advertisement
ABOUT DRAWING SOFTWARE VERSION
This manual explains the drawing software functions of the following versions.
• GT Designer3 Version1.108N
• GT Designer2 Version2.111R or later
For GT Designer3 of a version older than the above one and GT Designer2, some functions are not supported.
Therefore, displayed screens, setting items, and others may differ from those described in the manual.
For the functions added by version upgrade of the GT Designer2, refer to the following.
For the functions added by the version upgrade of GT Works3, contact your local distributor.
HOW TO USE THIS MANUAL
Symbols
Following symbols are used in this manual
Memory check operation
Carries out write/read check of memory.
POINT
POINT
POINT
When drive is not displayed
When the drive (memory) to check is not displayed, confi rm the mounting procedure or memory type with reference
to the following.
When no faults are found in mounting, etc, a memory failure may be arosen.
Replace the CF card or USB memory or built-in flash memory (C drive).
For details of built-in flash memory, contact yo ur local Mitsubishi (Electric System) Service.
The following example explains about Memory Check using built-in flash memory (C drive).
For the Built-in CF card (A drive) memory check or Extended memory card (B drive) memory check, install the CF card
before carrying out the same key operations as built-in flash memory. For the USB drive (E drive) memory check, install
the USB memory before carrying out the check operations.
1.
Select [Flash Memory] in the Memory check setting screen.
If select
OK
button, the numeric keyboard window is
displayed.
If select
Cancel
2.
Touch to input password (
key.
If touch
Enter
key,executes read/write check for the built-in
flash memory, which is completed in around 10 seconds.
*
The above is different from the actual page, as it is provided for explanation only.
A - 22
GT Designer2 Version 2 Screen Design Manual
(Hardware) 8.3.2
CF Card
(Hardware) 8.5.2
Install USB peripheral devices
4.3.7 USB device status display
button, returns to the initial menu.
5 9 2 0
) and touch
Enter
5.1 Diagnostic Functions
POINT
POINT
POINT
1
HINT
HINT
HINT
2
Show the items including detailed explanation
Hardware
GT16 User's Manual (Hardware)
Basic Utility
3
GT16 User's Manual (Basic Utility
4
Shows the operation steps.
Operate the steps from the step 1.
5
6
7
5 - 5
Refers to information
required for operation.
Refers to information useful
for operation.
: Shows the setting item displayed on
the software screen or the GOT
screen.
: Refers to a button displayed on
the computer screen or the
GOT screen, or a key of the
computer keyboard.
Advertisement
Table of Contents
