Table of Contents
Advertisement
3.1.4
Communication setting operation
Channel-Driver assign operation
The following describes how to operate the Channel-Driver assign.
The example of changing to the direct CPU connection (Communication driver: "A/QnA/L/QCPU, L/QJ71C24") for
the GOT of the computer link connection (Communication driver: "AJ71QC24, MELDAS C6*") is used.
POINT
POINT
POINT
Before the operation
The GOT automatically restarts after executing this setting.
If project data has been downloaded, the GOT starts monitoring of the controller after restarting.
Execute this setting after carefully confirming the safety.
(Continued to next page)
1.
Install communication driver "A/QnA/L/QCPU,
L/QJ71C24" to GOT.
(Download of [Communication Setting] from GT
Designer3 or GT Designer2 is not required.)
After installing communication driver, touch the
[Channel Driver assign] button in
[Communication Setting].
2.
Touch the [Change assignment] button on the
dislayed screen as shown left.
3.1 Communication Setting
1
2
3
4
5
6
7
3 - 7
Advertisement
Table of Contents
