Table of Contents
Advertisement
Step 2. Mounting Media Cards to the NIC
Overview
Media Card
Mounting
Step 3. Mounting Network Cards in the 4100ES-S1
The 4100-6014 Network Interface Card (NIC) uses media cards to connect to other NICs.
This section describes how the media cards are mounted onto NICs.
NICs connect to each other via the two types of media cards. The types of media cards in
the right and left ports are determined by the type of wiring that is being used between
cards.
Connect P1 on the wired media card, or J1 on the fibre media cards, to P5 (the left port)
on the NIC.
To connect a second media card to the same NIC, connect it as described above, but use
P6 (the right port) on the NIC. Note that any two types of media cards can be connected
to the same NIC.
STANDOFFS FIT INTO HOLES
CONNECTION
(MEDIA CARD
P1 OR J1 TO
4100-6014 NETWORK
INTERFACE CARD
The 4100 NIC daughter card inserts into motherboards as follows:
If the 566-227 CPU Motherboard (default for 4100ES-S1) or 565-275 CPU
Motherboard is used, the NIC daughter card is inserted into connector J2.
If the 565-274 CPU Motherboard is being used, the NIC daughter card is
inserted into connector J1.
40-PIN
NIC P5)
Figure 3-6. Media Card Mounting
3-9
MEDIA CARDS
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P6)
Advertisement
Table of Contents
