Serial Utility Commands - Microscan QX-830 User Manual

Serial Utility Commands

Serial Utility Commands

Note: For a list of all K commands, see
Type
Read Rate
Counters
Device Control
Master Database
Part Number /
Checksum
Default/Reset/Save
7-2
Serial Commands
Command
<C> Enter Decodes/Second Test
<Cp> Enter Decode Percent Test
<J> Exit Decodes/Second and Decode Percent Tests
<a1> PDF417 Information
<N> No Read Counter
<O> No Read Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Good Read/Match Counter
<W> Good Read/Match Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<L1> Programmable Output 1
<L2> Programmable Output 2
<L3> Programmable Output 3
<I> Disable Scanner
<H> Enable Scanner
<G> Store Next Symbol Read to Database Index 1
<Gn> Store Next Symbol Read to Database Index n
<NEWM> New Master Load Status
<#> Display All Firmware Part Numbers
<#a> Display Application Code Part Number
<#b> Display Boot Code Part Number
<#f> Display FPGA Code Part Number
<!> Display All Available Firmware Checksums
<!a> Display Application Code Code Checksum
<!b> Display Boot Code Checksum
<!f> Display FPGA Code Checksum
<Z> Save Current Settings for Power-On
Save Current Settings as Customer Default
<Zc>
Parameters for Power-On
Recall Customer Default Settings and Save for
<Zrc>
Power-On
Recall Microscan Default Settings and Save for
<Zrd>
Power-On (Will not default "sticky settings")
QX-830 Compact Industrial Scanner User's Manual
on page A-8.
Name