Mitsubishi GT11 User Manual page 342

2 Handling of Batteries and Devices with Built-in Batteries in EU Member States
This section describes the precautions for disposing of waste batteries in EU member states and
exporting batteries and/or devices with built-in batteries to EU member states.
(1) Disposal precautions
In EU member states, there is a separate collection system for waste batteries. Dispose of batteries
properly at the local community waste collection/recycling center.
The following symbol is printed on the batteries and packaging of batteries and devices with built-in
batteries used for Mitsubishi Graphic Operation Terminal (GOT).
The symbol indicates that batteries need to be disposed of separately from other wastes.
17 - 5 17.4 Battery Voltage Low Detection and Battery Replacement
Example of alarm output to external device (lamp, buzzer, etc.)
The following describes an example of outputting the battery voltage low signal from
a FX series PLC to an external device with system information.
Condition: The Write Device is "D20" and all data is used (the
clicked on the setting screen of drawing software) for the system
information assignment.
D36 b12: Battery voltage low (System Signal 2-2)
Turned on upon a battery voltage drop.
Used as shown below in the sequence program.
RUN monitor
M8000
Battery voltage low
M32
For details of system information, refer to the following.
GT Designer2 Version
GT Designer3 Version
This symbol is for EU member states only.
The symbol is specified in the new EU Battery Directive (2006/66/EC) Article 20
"Information for end-users" and Annex II.
MOV D36 K4M20
Y***
"*" indicates the output number at which the external device is connected.
Screen Design Manual
Screen Design Manual (Fundamentals)
Symbol
Select All
Output to external device of PLC
Activated the output upon battery
voltage low detection.
button is