Protective Cover For Oil; Applicable Protective Cover For Oil; Installation Procedure - Mitsubishi GT11 User Manual

8.8 Protective cover for oil

Use of the protective cover for oil improves waterproof property, oil resistance, and chemical resistance of
the GOT.
8.8.1

Applicable protective cover for oil

The following protective covers for oil are applicable to the GT11
Product name
Protective cover for oil GT05-50PCO
8.8.2

Installation procedure

Before attaching protective covver for oil
1 When the USB environmental protection cover is installed on the GOT,
remove the cover.
2 After removing the cover, put the USB connector protective sticker on the
USB connector.
3 Check that the rubber packing is installed on the GOT rear face, and
then fit the protective cover for oil to each corner of the GOT front face.
Position the POWER LED frame of the cover to the POWER LED on
the GOT front face.
4 Spread the protective cover for oil so that it covers the
rubber packing part on the GOT rear face.
For keeping liquids and others out of the control panel,
make sure that the rubber packing part is completely
covered.
Model
For 5.7" GOT
For attaching the protective cover for oil to the GOT already mounted on the control
panel, follow the procedures as below.
• Remove the GOT from the control panel. Make sure to externally shut off all
phases of the power supply and remove all cables from the GOT in
advance.
• Clean dirt off surfaces of the GOT and control panel.
.
Contents
Make sure that corners of protective
cover for oil match those of GOT front.
8.8 Protective cover for oil
8.8.1 Applicable protective cover for oil
1
2
3
4
5
6
Fit the cover to each
GOT corner.
7
8
8 - 13