Mitsubishi GT11 User Manual page 370

Setting items
Memory check
Drawing check
Font check
Touch panel
check
I/O check
NETWK unit
status display
System alarm
display
GOT start time
Screen cleaning
Maintenance report
*7
Integrated value
reset
*1: It is necessary to perform the followings by drawing software.
*2: The following display and operations are not allowed with the GT11.
*3: It is necessary to set the security level by drawing software.
*4:
*5:
*6: GT11 will display only the GOT error and CPU error.
*7: It is necessary to mount the option function board and battery.
App - 15 Appendix 2 Usage Condition of Utility Function
A drive memory check (Standard CF card)
C drive memory check (Built-in flash
memory)
D drive memory check (Built-in SRAM)
Missing bits, color, draw, display and
overlap display check of liquid crystal
Installed fonts check
Touch panel operation check
Connected target confirmation
Self-loopback check
Monitoring of the LED status display of the
MELSECNET/H communication unit and
CC-Link communication unit (GT15-
J61BT13)
Displaying GOT errors, CPU errors,
network errors
Resetting GOT errors
Displaying GOT start date and time, current
time, accumulated operating hours
Displaying the screen to clean the display
section
Backlight maintenance notification time
setting
Display section maintenance notification
time setting
Touch key maintenance notification count
setting
Built-in flash memory maintenance
notification count setting
Function to reset the values of backlight
maintenance notification time counted for
maintenance time report, display section
maintenance notification time, touch key
*7
maintenance notification count and built-in
flash memory maintenance notification
count
• Installation of communication driver
• Assignment of channel No. and communication driver
• Chinese (Traditional) cannot be displayed.
• Japanese and Chinese (Simplified) cannot be selected on the GOT screen.
(Japanese and Chinese (Simplified) fonts cannot be installed at the same time.)
Mount a battery as necessary.
It is necessary to mount a RS-232 connector for test. (
: Applicable
Function
*5
Section 14.10 I/O Check)
: Not Applicatble - : Not required
GT Soft
GT15 GT11
GOT 1000
-
*6
-
-
-
-
-
Drawing
Setting