Pg Speed Control Card Terminals And Specifications - Omron SYSDRIVE 3G3RV Series User Manual

n Preventing C and D Option Card Connectors from Rising
After installing an Option Card into slot C or D, insert an Option Clip to prevent the side with the connector
from rising. The Option Clip can be easily removed by holding onto the protruding portion of the Clip and
pulling it out.
A Option Card mounting spacer
(Provided with A Option Card.)
Option Clip
(To prevent raising of
C and D Option Cards)
3CN
D Option Card connector*
* An Option Card in Mounting Location D is supported by Asian Models only. Other models do not have the CN3 connector shown in Fig 2.34.
K K K K

PG Speed Control Card Terminals and Specifications

The terminal specifications for the PG Speed Control Cards are given in the following tables.
n3G3FV-PPGA2
The terminal specifications for the 3G3FV-PPGA2 are given in the following table.
Terminal
TA1
TA2
-48
2
A Option Card mounting spacer hole
4CN
A Option Card connector
2CN
C Option Card connector
A Option Card
Fig 2.34 Mounting Option Cards
Table 2.25 3G3FV-PPGA2 Terminal Specifications
No. Contents
1
Power supply for pulse generator
2
3
+12 V/open collector switching ter-
minal
4
5
Pulse input terminal
6
7
Pulse motor output terminal
8
(E) Shield connection terminal
C Option Card mounting spacer
C Option Card
D Option Card
D Option Card mounting spacer
A Option Card mounting spacer
Specifications
12 VDC (±5%), 200 mA max.
0 VDC (GND for power supply)
Terminal for switching between12 V voltage input
and open collector input. For open collector input,
short across 3 and 4.
H: +4 to 12 V; L: +1 V max. (Maximum response fre-
quency: 30 kHz)
Pulse input common
12 VDC (±10%), 20 mA max.
Pulse monitor output common
-