Steps To Run Mail In Dynamic Weighing Modes - Neopost IS-5000 User Manual

Running Mail Using the Dynamic Weighing Module
The Dynamic Weighing Module uses a four-point detection system to weigh and rate
mail. It measures the length, width, thickness and weight to properly determine the
mailing format within the mail class (that is to say letter vs. large letter formats) and
rate the mail pieces. Two modes are available when using the Dynamic Weighing
Module:
Dynamic weighing : the Dynamic Weighing Module measures and weighs each
•
piece. Use this for mixed mail rating.
Weigh First Piece : the Dynamic Weighing Module only measures and weighs the
•
first piece for an identical batch of mail. Use this to validate the correct rate for the
first piece. By using this mode, you will set the mail class for reporting and print the
mail class die, that is to say "Presort First Class", on the envelope.

Steps to Run Mail in Dynamic Weighing Modes

Steps to Run
Mail in Dynamic
Weighing Modes
In Dynamic Weighing mode
From the home screen:
1
Place your stack of mail
in the hopper.
For more details, see
Using the Feeder
2
Press to start pro-
cessing the stack.
The system will now
feed (seal), weigh, rate,
imprint and stack the
mail.
At any time, to stop the motors and printing, press
machine will process mail piece(s) already in system and then
stop.
Batch Mode
In (
1
Place your stack of same size/weight mail in the hopper.
For more details, see
2
Press to start.
The system weighs the first mail piece and asks you to
confirm the postage amount before applying it to all the mail
pieces.
3
Press [OK] to confirm.
The system will now feed (seal), imprint and stack the mail
without weighing the remainder of the batch.
( )
p.79 .
)
Using the Feeder
. The
p.79 .
3
43