Adjustment Item - Sony DSR-300 Service Manual

(4) When replacing the CCD unit, be sure to perform the
following adjustment items.
7-3-13. Shading Adjustment
7-3-14. Flare Adjustment
(5) If the amplitude level of the measured waveform is
blurred on the waveform monitor screen, set the
RESPONSE switch on the waveform monitor to
"LUM" mode.
(6) Be sure to perform the following adjustments
successively.
7-3-4. Y/R-Y/B-Y CLP Level Adjustment
7-3-5. Y/SYNC/R-Y/B-Y Level Adjustment
7-3-6. Carrier Balance Adjustment
7-3-7. Chroma (VBS) Level Adjustment
7-3-8. Y (VBS) Level Adjustment
7-3-9. Y (Y/C) Level Adjustment
7-3-10. Chroma (Y/C) Level Adjustment
DSR-300/P(E)/V1

7-1-5. Adjustment Item

7-2. Preparation before Adjustment
7-2-1. Color Bar Signal Confirmation
7-2-2. Sensitivity Confirmation
7-3. Adjustment
7-3-1. Character Size Adjustment
7-3-2. Subcarrier Frequency Adjustment
7-3-3. INT SC-H Phase Adjustment
7-3-4. Y/R-Y/B-Y CLP Level Adjustment
7-3-5. Y/SYNC/R-Y/B-Y Level Adjustment
7-3-6. Carrier Balance Adjustment
7-3-7. Chroma (VBS) Level Adjustment
7-3-8. Y (VBS) Level Adjustment
7-3-9. Y (Y/C) Level Adjustment
7-3-10. Chroma (Y/C) Level Adjustment
7-3-11. VF SYNC/BLKG Level Adjustment
7-3-12. CCD Output Level Adjustment
7-3-13. Shading Adjustment
7-3-14. Flare Adjustment
7-3-15. TONE Level Adjustment
7-3