Sony DSR-300 Service Manual page 115

Setting the Battery Before End
1. Set the SYSTEM MENU (refer to section 2-25-2), and
select the "Battery before end setting mode (Menu No.
501)." (Refer to Fig. A.)
2. Press the RESET (MENU SET) button to blink the
voltage displayed on the display window (Fig. B). Input
the desired voltage measured with the digital voltmeter
into the DC IN connector. (Fig. 1)
3. Press the RESET (MENU SET) button. (The value set
will be written in the EEPROM) and "YES" will be
displayed when the desired voltage is set (Fig. C). "no"
will be displayed when an error occurs while writing in
the EEPROM and the value could not be set (Fig. D).
In this case, repeat steps 1 to 3.
Note: The voltage value shown on the display
window is for reference only.
Setting the Battery End
1. Set the SYSTEM MENU (refer to section 2-25-2), and
select the "Battery end setting mode (Menu No. 502)."
(Refer to Fig. A'.)
2. Press the RESET (MENU SET) button to blink the
voltage displayed on the display window (Fig. B').
Input the desired voltage measured with the digital
voltmeter into the DC IN connector. (Fig. 1.)
3. Press the RESET (MENU SET) button to write the set
value in the EEPROM. "YES" will be displayed when
the desired voltage is set (Fig. C'). "no" will be
displayed when an error occurs while writing in the
EEPROM and the value could not be set (Fig. D'). In
this case, repeat steps 1 to 3.
. . . . . VTR operations stop according to the
Note:
battery end voltage set. Set the voltage as
±
10.95 0.01 V.
. . . . . The voltage value shown on the display
window is for reference.
. . . . . If this menu is set by mistake, always press
the MENU button to exit this menu. Never
press the RESET (MENU SET) button.
When pressing the RESET (MENU SET)
button, the data being set will be written.
DSR-300/P(E)/V1
Display window (LCD)
A
Blinking menu No. (When changed)
B
Voltage and A/D coversion value can be input
C
Save OK
D
Save NG
Display window (LCD)
A'
Blinking menu No. (When changed)
B'
Voltage and A/D coversion value can be input
C'
Save OK
D'
Save NG
2-39