Replacing The Filter - Sony DSR-300 Service Manual

2-20. REPLACING THE FILTER

Type of filter
3200/3000 K
5600 K
5600 K + 1/8ND
5600 K + 1/64ND
CROSS (sold separately)
*When attaching the cross filter, put the crosshatching
side outside.
1. Remove the three precision screws (K2 x 5) and
remove the optical filter unit.
2. Turn the filter knob to meet the filter to be replaced.
3. Loosen the two precision screws (K1.7 x 5) which are
fixing both sides of the filter to move the filter fixing
wings as shown in Fig.
4. Take a grip on the handle, pan the camera downward,
and take a filter by the other hand. Be sure to cover the
hand with clean cloth, such as a gauze, when picking
up the filter in order to keep the surface of filter
cleanly.
5. Attach the replacement filter in the reverse order of
above.
Point to notice when attaching the filter:
1. Place the filter on the filter disc by holding the
circumference of the filter.
2. Fine adjust the position of filter with tweezers.
Note:
After the filter replacement, perform the filter indication
setting Page 23 of menu. (Refer to section 2-26-3.)
DSR-300/P(E)/V1
Sony Part No.
3-708-372-01
3-708-372-21
3-612-636-01
3-612-636-11
3-200-281-01
Filter fixing wings
Precision screw
1.7 x 5
(Loosen)
Precision screw
Replacement
1.7 x 5
filter
(Loosen)
Precision
screws
K2 x 5
Optical filter unit
Filter knob
Gauze
2-45