Sony DSR-300 Service Manual page 30

Using Accessories
Fitting the Shoulder Strap
This section describes the procedure for fitting the
supplied shoulder strap to the camcorder.
1
Fit one of the clips to a
shoulder strap fitting.
2
Fit the other clip to the
shoulder strap fitting on the
other side of the grip in the
same way.
Removing the shoulder strap
Open the cover of the clip and move
the clip downwards to release it
from the fitting.
38
Chapter 2 Fitting and Connections
1 Open the cover of
the clip.
2 Hook the clip over a
shoulder strap
fitting.
Connecting to Audio System
The DSR-300/300P is able to record sound not only
from the microphone attached but also from a wireless
microphone or an external audio system.
Using a wireless microphone system
You can use the wireless microphone system
including a WRT-810A/830A UHF Wireless
Microphone and a WRR-810A/855A/860A UHF
Portable Tuner to record sound.
To connect a WRR-855A
1
Open the cover of the WRR
connector.
2
Insert the WRR-855A into the
CA-WR855.
3
Fit the attachment plate on the
rear side of the CA-WR855 to
the V-groove on the battery
attachment interface, and then
slide the CA-WR855 down
until it connects to the WRR
connector.
4
Set one of the AUDIO IN (CH-
1/CH-2) switches to WRR.
For details on using the wireless microphone system, see the
operating instructions for the microphone and tuner.
WRR connector
Fasten the screws (supplied with
the WRR-855A).
CA-WR855
39
Chapter 2 Fitting and Connections