Sony DSR-300 Service Manual page 120

Digital camcorder index picture board camera adaptor
Hide thumbs Also See for DSR-300:
Table of Contents

Advertisement

Setting the BP Battery Preset
1. Set The SYSTEM MENU (refer to section 2-25-2), and
select the "BP battery preset mode (Menu No. 513)."
(Refer to Fig. E")
2. Press the RESET (MENU SET) button to blink the
voltage on the display window (Fig. F").
3. Press the SHIFT button while pressing the ADVANCE
button.
4. Note down the voltage on the display window.
5. Change the value by pressing the ADVANCE button,
and move to the next digit with the SHIFT button (Fig.
G").
For your reference, the voltage increases by about 0.02 V
when the right digit value is increased by one step.
6. Press the RESET (MENU SET) button to write the set
value in the EEPROM. "YES" will be displayed when
the desired voltage is set (Fig. H"). "no" will be
displayed when an error occurs while writing in the
EEPROM and the value could not be set (Fig. I"). In
this case, repeat steps 1 to 6.
. . . . . Set the voltage as 12.97
Note:
. . . . . The voltage value shown on the display
window is for reference.
. . . . . If this menu is set by mistake, always press
the MENU button to exit this menu. Never
press the RESET (MENU SET) button.
When pressing the RESET button, the data
being set will be written.
. . . . . If the value at step 4 was not taken down,
change the value using the values at
shipment on the previous page as reference.
2-44
±
0.01 V.
Display window (LCD)
E"
Blinking menu No. (When changed)
F"
The voltage display blinking
G"
A/D conversion value blinking display
H"
Save OK
I"
Save NG
DSR-300/P(E)/V1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsr-300pDsbk-301Ca-wr855

Table of Contents