Sony DSR-300 Service Manual page 56

Using SetupLog
The SetupLog function records camcorder settings
every few seconds at shooting and displays the
recorded data in the viewfinder during playback.
To view the SetupLog Data, perform the following
procedure.
1
Turn the power on and load the tape that contains
the recording to be viewed.
2
Play back the tape.
For details of playback operation, see page 58.
3
Press the MENU switch upward (to STATUS
position).
The display changes to page 1 of the status display.
P L A Y
T C R 1 2 : 3 4 5 6 : : 0 0
S E T U P L O G 1 / 3 W A :
W H I T E : A 6 0 0 0
A . I R S I : S T D
Settings during
M A T R X I : S T D
recording
D C C + : O N 0
S K I N D T L : O F F
Each time you press upward the MENU switch, the
status display cycles through the status pages and
playback display in the order: page 2, page 3, the
playback display (containing the current settings),
and page 1.
90
Chapter 4 Viewfinder Screen Indications and Menus
Status display (page 2)
P L A Y
T C R 1 2 : 3 4 5 6 : : 0 0
S E T U P L O G 2 / 3 W A :
: ± 0
A . I R S I
: ± 0
D T L L E V
: ± 0
M . B L C K A
: ± 0
S T R E C H T 0
S S : 1 / 1 0 0
Status display (page 3)
P L A Y
T C R 1 2 : 3 4 5 6 : : 0 0
S E T U P L O G 3 / 3 W A :
: ± 0
M . G A M A M
L E V : ± 0
V D T L
D T L F R E Q : M
: ± 0
S K I N S A T 0
: ± 0
S K I N H U E
S A T :± 0
H U E :± 0
Note
In the following cases, changed settings that were not
recorded may appear as blank settings.
• SetupLog data is overwritten at intervals of a few
seconds during recording. If the settings are changed
frequently for certain items, it may not always be
recorded in time.
• If the recording time is very short, recording may be
ended before all of the data has been overwritten.
Setting on the VCR Section — VCR Menu
You can use the VCR menu for settings on the VCR
section.
Operation
Real time clock and calendar settings
Cumulative hour counts:
• Head drum operating hours
• Tape transport hours
• Operating (power-on) hours
Frame mode selection for time code (DSR-300 only)
Battery capacity indication selection
Standby-on period setting
Use auto-check function
Selection of ClipLink function
Audio recording mode selection
Audio reference level selection
Fade-in/fade-out setting for the audio recording start and stop points
Use setup add (DSR-300 only)
Menu No. Reference
101 Page 93
201 Page 93
204 Page 93
206 Page 94
207 Page 94
210 Page 95
211 Page 97
212 Page 97
213 Page 98
214 Page 98
220 Page 99
91
Chapter 5 Adjustments and Settings