Psw-56 Board - Sony DSR-300 Service Manual

2-11-17. PSW-56 Board

1. Remove the CN-1444 and SW-888 boards.
(Refer to sections 2-11-15 and 2-11-16.)
2. Remove the screw (B2.6 x 8).
3. Disconnect the flat cable (CN306) and connector
(CN302) from the PSW-56 board, and remove the
PSW-56 board in the arrow direction.
Point to notice when attaching the board:
Be sure to hook the claw to the hole.
2-11-18. CC-68 Board
1. Remove the mechanical deck. (Refer to section 2-10.)
2. Disconnect the flexible card (CN1) from the CC-68
board.
3. Remove the two screws (PWH1.4 x 2.5) and remove
the CC-68 board.
2-26
PSW-56 board
Claw
CN302 CN306
CC-68 board
Mechanical deck
Hole
Screw
B2.6 x 8
CN1
Screws
PWH1.4 x 2.5
DSR-300/P(E)/V1