Sony DSR-300 Service Manual page 31

Using Accessories
To connect a WRR-810A/860A
Attach the WRR tuner fitting (not supplied) to the rear
of the camcorder as shown in the following figure.
2,3
1
1
Pass a screwdriver through the holes and tighten
the screws .
2
Loosen the adjustment screws.
3
Adjust the metal fitting position for a battery
pack to be attached, and tighten the adjustment
screws to fix its position.
Using an external audio system
Connect an audio mixer or other external audio system
component to the AUDIO IN CH-1/CH-2 connector as
shown below.
AUDIO IN (CH-1/CH-2) switches: Set to REAR.
AUDIO IN
CH-1/CH-2
40
Chapter 2 Fitting and Connections
4
5
4
WRR-810A/860A
4
Attach the holder kit (two fittings and four screws,
supplied with the tuner) to the WRR tuner fitting
(one for the upper position and the other for the
lower position).
5
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting, contact your Sony
dealer.
CH-1 CH-2
AUDIO IN
FRONT
VJ MIC
WRR
REAR
Input selection switch: Set to LINE.
+48V ON
LINE MIC
To audio mixer, etc.
Fitting to a Tripod
First fit the VCT-U14 Tripod Adaptor to the tripod,
then mount the camcorder on the tripod adaptor.
VCT-U14 Tripod Adaptor
Side the camcorder forward
Tripod
along the slot, until it clicks
firmly into place.
Removal
Hold down the red button
and pull the lever in the
direction of the arrow.
Note
After removing the camcorder, if the tripod adaptor pin
has not returned to its original position, hold down the
red button and move the lever in the direction of the
arrow to return the pin to its original position. It is not
possible to mount a camcorder with the pin left out.
Pin
41
Chapter 2 Fitting and Connections