Menu Operation - Sony DSR-300 Service Manual

6-3. MENU OPERATION

Service Mode
There are the three major menus, BASIC menu and
ADVANCE menu for user, and SERVICE menu.
The unit enters the service mode by setting the switch
S811 (OPE/ADJ) on the FP-98 board to ADJ position.
In service mode, the following menu select screen is
displayed:
Menu select screen
OPEN MENU (YES PUSH)
SERVICE
Operation of Menu Select Screen
1. To move the cursor
Each time the menu switch is pushed toward "OFF,"
the cursor moves in between the OPEN MENU and
menu name.
The status screen is displayed by pulling the menu
switch toward "ON."
The cursor can be moved by turning the menu dial
during blinking the cursor.
2. To select the menu
Turn the menu dial during blinking the menu name. As
turning of the MENU dial, the following menu names
will be appeared cyclically.
SERVICE 5 BASIC 5 ADVANCE 5 SERVICE
When the cursor is moved to the menu name with menu
dial, the cursor blinks. In this case, change the menu
name after changing the blinking section from cursor to
menu name by turning the menu dial.
When the menu dial is pressed during blinking the
menu name, the cursor blinks.
3. To open the selected menu
Display the menu name to be opened. Move the cursor
to OPEN MENU and push the menu dial. The first
page of the selected menu is displayed.
After the menu selection, usual menu operation can be
carried out.
When the selected menu had been finished, menu select
screen is displayed.
DSR-300/P(E)/V1 6-5