Menu (Lcd); User Menu - Sony DSR-300 Service Manual

2-25. MENU (LCD)

The display window (LCD) of this unit enables setting of
the system functions of this unit, and VTR menus required
for adjustments and maintenance.
The VTR menus are divided into the following three:

. USER MENU

For user operations.
. SYSTEM MENU
Used to set various system functions of this unit (This
menu is not described in the instruction manual and
therefore cannot be used by users.)
. MAINTENANCE MENU
Used for performing maintenance including adjustments.
2-25-1. User Menu
Operating the USER MENU
1. Press the MENU button in the TC panel.
(The time data display on the display window changes
to the menu display.)
The display window (LCD) displays "101 xxxx" and
the USER MENU is set. (Fig. A.)
2. Press the ADVANCE button repeatedly until the Menu
No. on the display window (LCD) becomes the desired
Menu No.
Pressing the ADVANCE button (+ button) will switch
and display the menu in the following order.
101 → 201 → 204 (DSR-300)/206 (DSR-300P)···215
(DSR-300)/214 (DSR-300P) → 101···.
3. To display the desired Menu No., press the SHIFT
button. The current value set will blink, enabling the
value to be changed. (Fig. B.)
4. To advance to the next digit, press the SHIFT button.
To change the set value, press the ADVANCE button
and display the desired value.
5. Press the RESET (MENU SET) button.
The set value is registered, and the Menu No. blinks
again. (Fig. C.)
6. Press the MENU button.
The display window (LCD) returns to the state before
the menu display.
Note: If the MENU button is pressed during
operations, the menu will be exited without
registering changes made in the settings.
2-58
Basic Operations of Buttons
Button
ADVANCE button
SHIFT button
RESET (MENU SET) button Registers the set value
MENU button
WARNING
RESET
RESET
(MENU SET)
button
(MENU SET)
REC TIME SKIN DTL EXT VTR MENU ADVANCE
OUTPUT
TTL
ON COMPONENT.
DUR OFF VBS
OFF Y/C
TTL RESET SET PRESET
MONITOR SELECT
VTR
TRIGGER CH-1
MIX
CH-2
PARALLEL
EXT
INT ONLY
DATE/TIME
EXT ONLY
HYPER MATRIX
ClipLink
GAIN FRONT MIC
CONTINUE
LOW CUT
H.SAT
ON
FL
ON
OFF
STD OFF
MENU button
ADVANCE button
Display window (LCD)
A
Initial display
B
Blinks when the set value is changeable
C
Blinking menu No. (When changed)
Function
Changes the set value
Menu No. + (Increase)
Moves between displayed digits
Menu No. _ (Decrease)
(Returns to the menu selection
mode)
Start the adjustment
Returns to the state before the
menu mode
Interrupt the adjustment
Display window (LCD)
LIGHT
OVER dB OVER
PB DATE NDF EXT-LK HOLD
ON
0
OFF
-12
H MIN SEC FRM
-20
CLIP CL CONT IP
DISPLAY
-30
TAPE DVCAM
COUNTER
-40
BATT E F Li ∞
TC
-
F U-BIT
DIAG 1 8 32k 2
RF SERVO HUMID SLACK
F
8 48k
SHIFT
AUDIO LEVEL
F-RUN F-RUN
AUTO
MAN
AUDIO SELECT
REGAIN SET
CH-1 CH-2
LITHIUM BATT
R-RUN
AUDIO IN
MONITOR OUT
FRONT
CHARACTER
VJ MIC
WRR
REAR
ON
OFF
SHIFT button
DSR-300/P(E)/V1