Sony DSR-300 Service Manual page 25

Location and Function of Parts
DXF-701WS/701WSCE Viewfinder
Note
You can switch the scan size of the DXF-701WS/
701WSCE in accordance with the aspect ratio
1 BATT indicator
2 TAKE/TALLY indicator
3 REC/TALLY indicators
4 SHUTTER indicator
5 GAIN UP indicator
6 Eyepiece focusing knob
7 Accessory fixing screw hole
8 Tally lamp
Microphone holding screw
Microphone holder
Microphone a)
a) Not supplied with the optional DXF-701WS/701WSCE
1 BATT (battery) indicator (red)
This indicates when the battery capacity is low.
2 TAKE/TALLY indicator (orange)
When using the ClipLink function while shooting, this
indicator lights when the TAKE button (6 on page
11) has been pressed to set a Mark IN point and goes
out when a Mark OUT point is set.
28
Chapter 1 Overview
selected on the camera or camcorder. However, it
operates in 4:3 mode when used on the DSR-300/
300P.
TALLY
TAKE REC BATT
SHUTTER GAIN UP
Eye cup
9 Eyepiece release catch
0 BRIGHT control
!¡ CONTRAST control
!™ PEAKING control
!£ TALLY switch
!¢ Viewfinder connector
3 REC/TALLY (recording/tally) indicators (red)
• From the time when you press the VTR button (9 on
page 11 and !∞ on page 27) on the lens or
camcorder, this flashes until recording starts, then
stays on continuously during recording.
• This is also used to indicate a fault. (See page 115.)
• The lower indicator can be disabled by menu setting.
(See page 86.)
4 SHUTTER indicator (red)
This lights when the SHUTTER switch (5 on page
11) is in the ON position. (If the EVS is selected, the
indicator will not light.)
5 GAIN UP indicator (orange)
This lights when the gain is 3 dB or more.
6 Eyepiece focusing knob
Turn this to adjust the viewfinder focus to match your
eyesight. (See page 106.)
7 Accessory fixing screw hole
Attach optional video lights or other accessories here.
8 Tally lamp
When the TALLY switch !£ is in the ON position, this
operates in the same way as the REC/TALLY
indicators 3.
9 Eyepiece release catch
To view the viewfinder screen directly, press this
catch, and hinge up the eyepiece.
0 BRIGHT (brightness) control
This adjusts the brightness of the viewfinder image.
(See page 106.)
!¡ CONTRAST control
This adjusts the contrast of the viewfinder image. (See
page 106.)
!™ PEAKING control
This adjusts the outline intensity of the viewfinder
image. (See page 106.)
!£ TALLY switch
Set this switch to the ON position to use the tally lamp
8.
!¢ Viewfinder connector (20-pin)
Connect this to the VF connector.
29
Chapter 1 Overview