Replacing The Filter - Sony DSR-570WS Service Manual

1-3. Replacing the Filter

Type of filter
No.1 3200 K
No.2 5600 K + 1 / 8ND
No.3 5600 K
No.4 5600 K + 1 / 64ND
5600 K + 1 / 4ND ( Sold separately )
5600 K + 1 / 16ND ( Sold separately ) 3-708-637-31
5600 K + 1 / 32ND ( Sold separately ) 3-174-683-01
*
CROSS (sold separately)
* When attaching the cross filter, put the crosshatching side
outside.
1. Remove the three precision screws (K2 x 5) and
remove the optical filter unit.
2. Turn the filter knob to select the filter to be replaced.
3. Loosen the two precision screws (K1.7 x 5) fixing both
sides of the filter and open the filter fixing wings as
shown in the figure.
4. Hold the camera in a vertical position as shown in the
figure by grasping the camera handle, and the filter will
come off. At that time, put a clean cloth such as a gauze
on your hand so that the hand is clear of the filter
surface.
5. Attach the replacement filter in the reverse order of
above.
Point to notice when attaching the filter:
1. Place the filter on the filter disc by holding the edge of
the filter.
2. Align the position of filter with tweezers.
n
After the filter replacement, perform the filter indication
setting SERVICE menu of Page 20.
(Refer to Section 4-2-3.)
DSR-570WS/570WSP V1
Sony Part No.
3-708-637-01
3-174-685-01
3-708-637-21
3-174-684-01
3-708-637-11
3-174-682-01
Filter fixing wings
Precision screw
1.7 x 5
(Loosen)
Precision screw
Replacement 1.7 x 5
filter
(Loosen)
Precision
screws
K2 x 5
Optical filter unit
Filter knob
Gauze
1-3