Cutter - Canon iPF6100 Service Manual

Chapter 4

4.3.6 Cutter

0016-8468
a) Removing the cutter unit
1) When removing the cutter unit, open the top cover, and then remove the roll feed unit, output guide, left and
right circle covers, tank cover, left front cover, right upper cover, operation panel, exhaust filter, lower rear
cover, right cover, right front cover, upper front cover, lower front cover. Refer to DISASSEMBLY/
REASSEMBLY > Points to note on Disassembly and Reassembly > External Covers.
2) Turning motor pulley[1] in the arrow direction, move cutter[2] about 2 cm to the right of the leftmost end.
[1]
[2]
F-4-35
4-20