Canon iPF6100 Service Manual page 312

Chapter 7
c) ADJUST
Performs adjustments and prints the adjustment and check patterns necessary for adjusting the printer parts.
1) PRINT PATTERN
Display
NOZZLE 1
OPTICAL AXIS
LF & HAKUSHA
SENSOR CHECK
LF & HAKUSYA and SENSOR CHECK are intended for factory adjustment purposes.
No adjustment by service personnel is required.
2) HEAD ADJ.
Set or initialize the registration adjustment values of each printheads.
Display
AUTO ROUGH
HEAD ADJ
MANUAL DETAIL
HEAD ADJ
BASIC
ADJ. A to A-1 to
SETTING F F-1
SAVE
SETTINGS
7-16
Prints the nozzle check pattern by single direction/ single pass without using the
non-discharging back up.
It is used to check for the non-discharging nozzles.
- Media size: A4
- Media type: any
Prints the pattern and adjusts the optical axis of the multi sensor.
For details, refer to "Disassembly/Reassembly" > "Adjustment and Setup Items" >
"Procedure after replacing the carriage unit or multi sensor".
- Media type: photo glossy paper
* For Factory
* For Factory
Prints the pattern for auto head adjustment (rough adjustment).
Prints the detail patterns for the manual head adjustment.
After printing, the mode will change to [ADJ. SETTING]. Check the printed
patterns and input the set values.
Prints the basic patterns for the manual head adjustment.
After printing, the mode will change to [ADJ. SETTING]. Check the printed
patterns and input the set values.
This mode is to input the registration adjustment values.
It is possible to return the values to the former one by printing the status print
before changing the value.
Save the registration adjustment values that has been input.
T-7-12
Description
T-7-13
Description