Canon iPF6100 Service Manual page 57

[Interface Setup]
Setting Item
[EOP Timer]
[TCP/IP] [TCP/IP]
[IP Mode]
[Protocol]
[IP Setting]
[NetWare] [NetWare]
[Frame Type]
[Print Service]
[AppleTalk]
[Ethernet [Auto Detect]
Driver]
[Comm.Mode]
[Ethernet Type]
[Spanning
Tree]
[MAC Address]
[Ext.Interface]
A confirmation
message is
displayed if you
press the
button. Choose
OK to restore
the network
settings to the
default values.
T-1-18
Specify the timeout period for print jobs.
Specify the TCP/IP protocol settings. To apply your
changes, choose Store Setting .
Choose whether the printer IP address is configured
automatically or a static IP address is entered manually.
[DHCP] Specify the protocol used to configure the IP address
automatically.
[BOOTP]
[RARP]
[IP Address] Specify the printer network information when using a
static IP address.
[Subnet Mask]
Enter the IP address assigned to the printer, as well as the
[Default G/W]
network subnet mask and default gateway.
Specify the NetWare protocol. To apply your changes,
choose Store Setting .
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply
your changes, choose Store Setting .
Specify the communication method. To apply your
changes, choose Store Setting .
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings
values of Comm.Mode and Ethernet Type .
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over
the LAN.
Displays the MAC address.
When installing the expansion interface board, choose
whether the expansion interface board is used.
A confirmation message is displayed if you press
the
settings to the default values.
Description, Instructions
button. Choose [OK] to restore the network
Chapter 1
1-45