Canon iPF6100 Service Manual page 198

Chapter 4
9) Turn the gear[1] so that the sensor flag of the lift gear[2] leaves the interrupt position of the lift cam sensor[3],
then remove the ring[4], the lift gear[2] and the lift cam[5]. Disconnect the connector[6], remove the two
screws[7], and then remove the lift cam sensor[3]. Remove the two torsion springs[8], pull out the carriage
rail[9] from the right side of the printer, and then remove the carriage.
[8]
b) Points to Note on disassembly and Reassembly of Carriage Unit
1) Align the mark on the gear[3] with the mark on the bushing[4]. Align the mark on the lift gear[1] with the
mark on the gear[2] to remove the ring[5].
4-26
[9]
F-4-45
[5]
[1]
F-4-46
[8] [2]
[5]
[3]
[7]
[2] [3] [4]
[4]
[6]
[1]