Canon iPF6100 Service Manual page 163

Chapter 3
(3) To secure the Stand Stay [2], use the M10 side of
the Wrench [1] to tighten hex nuts in four positions
on the top and bottom of both sides.
[1]
F-3-35
(4) Put the Stand Board [1] on the Stand, aligning the
right side of the Stand Board [2] with the right side
of the Stand [3].
[1]
F-3-36
Be careful not to pinch your fingers between the
Stand Board and Stand.
3-12
[2]
[2]
[3]
(5) To secure the Stand Board [3] to the Stand, use
the Allen Wrench [1] to tighten the four short Table
Bolts [2] in the order shown.
[2]
4
3
F-3-37
c. Assembling the Output Stacker
(1) Insert Basket Rod #1 [1] in the Basket Fastener
so that the hole [2] of Basket Rod #1 and the hole [3]
of the Basket Fastener on the right are aligned and
the Support Rod Holder [4] faces up.
F-3-38
[1]
[3]
2
1
[2]
[4]
[1]
[2]
[3]