Canon iPF6100 Service Manual page 53

[Paper Details]
Setting Item
(The paper type is [Roll
displayed here.) DryingTime]
[Scan Wait Time] Specify the time to wait for the ink to dry between each scan in
[Feed Priority]
[Adjust Length]
[Head Height]
[Skew Check Lv.] If you print on Japanese Paper Washi or other handmade paper that
[VacuumStrngth] Specify the level of suction that holds paper against the Platen .
[NearEnd
RollMrgn]
[Cut Speed]
[Trim Edge First] If a roll is loaded, the end of the paper will be cut.
T-1-16
Description, Instructions
Specify the time to wait for the ink to dry for each sheet.
bidirectional printing, in consideration of how quickly the paper
absorbs ink. Note that printing will take longer if you specify a wait
time.
Specify exact paper feeding, if desired. Normally, select Automatic .
Choose Print Length if you prefer to feed the paper an exact amount.
However, note that choosing Print Length may result in slight banding
in the direction of Carriage scanning.
Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage of the
current paper. For paper that tends to stretch, increase the feed amount
by setting the adjustment value toward +. For paper that tends to
shrink, decrease the feed amount by setting the adjustment value
toward -.
The setting for the amount of paper stretching or shrinkage is relative.
If you access it again later, it will be displayed as 0.00 %.
Adjust the Printhead height.
has an irregular width, choose Loose for a higher skew detection
threshold, or choose Off to disable skew detection. However, if paper
is loaded askew when detection is Off , note that paper jams or Platen
soiling may occur.
If strict skew detection is required, choose High Accuracy.
Specify a margin at the leading edge of roll paper to ensure better
printing quality at the leading edge.
Note that if you choose 3 mm , it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may be
scratched, and ink may adhere to the the leading edge.
Choose the cutting speed. For media such as film that are more likely
to generate debris when cut, choose Fast to reduce the amount of
debris.
Choose Forced to have 40 mm (1.6 in) cut off the leading edge of the
roll, ensuring a straight edge, after you load the roll. Scraps are then
removed.
When Automatic is selected, if the left and right side of the leading
edge of the roll are uneven (by 3 mm [0.12 in] or more), the edge is
cut an amount relative to the slant to ensure a straight edge after you
load the roll. Scraps are then removed.
If the unevenness is less than 3 mm or if No Cutting is selected, the
edge is not cut and scraps are not removed.
Chapter 1
1-41