Canon iPF6100 Service Manual page 344

Display massage
Hardware error. 03130031-2F17
03130031-2E17
Turn off printer,
wait, then
turn on again.
Hardware error. 03130031-2F2A
03130031-
2E2A
Turn off printer,
wait, then
turn on again.
Hardware error. 03030000-2F29
03130031-2E29
Turn off printer,
wait, then
turn on again.
Hardware error. 03130031-2F2E
03130031-2E2E
Turn off printer,
wait, then
turn on again.
Hardware error. 03130031-4027
03130031-4027
Turn off printer,
wait, then
turn on again.
03130031-2F13
Hardware error.
03130031-2E13
Turn off printer,
wait, then
turn on again.
Code* Condition detected
Pump encoder sensor error
Unable to detect the feed roller
home position
Feed motor timeout (Roll media)
Roll travel timeout
Lift travel timeout error
A/D converter external trigger
output stop detection hardware
error 1
Chapter 8
Action
Check the purge unit.
Check the feed roller encoder
and surrounding part.
Check to see if paper has not
jammed.
Check the roll feed unit. Check
roll media. Check to see if paper
has not jammed in the printer.
Check the roll feed unit.
Check the carriage unit and
surrounding parts.
If both printheads are signaled
faulty, take the following
corrective action:
1) Replace the left printhead
with a normal one.
2) Because the error indication
lasts, turn the printer off, then
back on.
3) Replace the right printhead
with a normal one, as the
automatic replacement of the
right printhead is suggested.
If a printhead is not at fault,
replace the main controller
board.
8-11