Water Connections - ALLIANCE BA120E Installation Manual

Installation
IMPORTANT: Flexible supply line/coupling must be
used. Solenoid valve failure due to hard plumbing con-
nections will void the warranty. It is recommended that
a filter or strainer be installed in the water supply line.

Water Connections

Electrical shock hazard. Can cause death or serious
injury. If the water dispensing system is activated do
not attempt to operate the dryer. If the water dispens-
ing system is activated have the dryer inspected by a
qualified agency before operating the dryer.
• CALL THE FIRE DEPARTMENT.
• DO NOT disconnect electric power to the dryer.
• DO NOT disconnect water to the dryer.
• DO NOT touch the dryer.
1. Fire Suppression System Control Box
2. Water Solenoid Valve
To connect the two hoses (supplied with tumble dryer), insert
rubber washers (from literature pack) in water inlet hose cou-
plings. Refer to Figure 4 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
WARNING
120
Connect tumble dryer to a backflow preventer (vacuum breaker)
before connecting to the public water main in all countries where
local regulations require specific water approval certificates.
Two hoses and a Y-connector are provided with the tumble dryer
to allow for connection of water supply to tumble dryer. DO NOT
reuse old hose sets.The water connections are made to the water
solenoid valve, located on the rear of the tumble dryer. The Y-
connector provides a single female hose connection (Standard US
3/4-11 1/2 NH thread). Refer to Figure 3 and Figure 4 .
W932
1
2
Figure 3
26
170/200
TMB2433N_SVG
Part No. 70532501ENR7