Maintenance; Technical Data - eKey Fingerscan Access Control System Operating Instructions Manual

General

Maintenance

11.
11.1 CARE
Generally speaking, your system does not require any maintenance. Apart from cleaning the sensor
surface occasionally when it is dirty, you are not required to do anything.
11.2 CLEANING
Care of the sensor area
The sensor area of the finger scanner is the most important element of your ekey home system and needs
to be taken care of accordingly in order to function reliably and durably.
The sensor area is self-cleaning, since fingers are being swept regularly over it, and therefore needs no
special maintenance. If the finger scanner still becomes dirty, wipe the sensor with a damp (not wet),
non-scratch or non-abrasive cloth. Use normal water without any cleaning agents. Be particularly careful
when cleaning the surface of the sensor. Do not rub on the sensor area or exert pressure on it.
Disposal
12.
In the event of a disposal of the product, please note the relevant legal provisions. Information on the
disposal of electrical and electronic equipment in the European Community:
Within the European Union the disposal of electrical devices is governed by national regulations based on
EU Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). All equipment delivered
th
after August 13 , 2005 must not be disposed of with municipal or household waste anymore. To
document this, they are marked with the following symbol
Since the disposal requirements vary from one EU country to country, please contact your supplier for
further details in case of need.

Technical Data

13.
The technical specification for each product (ekey home finger scanner and ekey home control panel) can
be found in the respective data sheets on the CD-ROM.
© ekey biometric systems GmbH
Sensor areas
Operating instructions ekey home Page 40 / 41