eKey Fingerscan Access Control System Operating Instructions Manual page 34

General
This relay time can only be set for the ekey home CP DRM 2.
7.) Press the button.
8.) You now are back to the main menu.
The duration of the impulse or the switching feature has thus been defined for the selected relay.
8.2.2.9 RESETTING TO FACTORY SETTINGS
If you carry out this procedure, then all the saved data will be irrecoverably deleted!
If you reset the device to its factory settings, all the user data (user fingers) in the memory are deleted.
The security code is reset to the standard value of 99, the control panel and the finger scanner are
disconnected from each other, and the relay switching times are set for all the relays at 3s.
DISPLA Y
START
1.) First enter the security code as per section 8.2.2.4.
2.) Select "Reset" in the main menu using the
3.) Press the button.
4.) A message appears on the display, asking you if you are sure you want to execute a RESET.
If you press the
If you press the
5.) After pressing
settings and delete all the enrolled fingers. At the end of the RESET procedure, you will be asked
on the ekey home CP DRM display to select a language, and the ekey home finger scanner lights
up orange.
Proceed from section 8.2.2.3 in order to set up your system anew from the factory settings.
© ekey biometric systems GmbH
ZnR ... status after reset;
Can
relay
mode) has been selected.
Enter sec urity DISPLA Y
code
Enter
security
code
Select the menu item
„Reset"
button, the reset will be done.
button, you will cancel this action and go back to the main menu.
, the procedure will take a couple of seconds. The system will reset all the
Operating instructions ekey home
only be modified if
time 00.00 (toggle
KEY DISPLA Y
STROKE
Press OK or ESC
buttons.
KEY DISPLA Y
STROKE
Page 34 / 41
FINISHED