Status Led - eKey Fingerscan Access Control System Operating Instructions Manual

General
7.3 OPTICAL SIGNALS ON THE EKEY HOME FINGER SCANNER
Your ekey home finger scanner is equipped with LEDs that deliver information on the operational state
and individual functions of your system. The optical signaling of the individual finger scanners will differ
though. The two tables below will show you the corresponding signals and their meanings.
The LEDs are named based on their purpose as
Status LED – for details on the operational state (finger recognized, finger rejected, etc.)
Function LED– for details on the function of the system (online, offline, etc.)
LED signals on ekey home FS OM, ekey home FS IN 2.0 and ekey home FS WM 2.0
ekey home FS OM
ekey home FS IN 2.0
ekey home FS WM 2.0
Normal mode
© ekey biometric systems GmbH
Function LED

Status LED

Function Status LED
LED
ORANGE
Left: OFF
flashing
Right: OFF
slow
Left: OFF
BLUE
Right: OFF
ORANGE
flashing Left: OFF
Right: OFF
quick
Left: OFF
GREEN
Right: OFF
Left: OFF
RED
Right: OFF
Left: OFF
ORANGE
Right:OFF
Operating instructions ekey home
Description
There is no bus connection to the ekey home control panel. Please check
the connection cables or apply „Initializing the devices" as described in
section 8.2.1.4 or 8.2.2.3.
The system is online – all components are communicating correctly.
Once you have drawn your finger over the sensor, the system will start
the processing (enrollment) and matching. The LED flashes orange
during the entire process.
Fingerprint recognition: positive, the relay switches.
Fingerprint recognition: negative or poor image, which does not allow
any fingerprint check.
Fingerprint enrollment mode. When enrolling a finger via the menu on
the control panel, this LED state indicates the system to be ready for
swiping a finger over the sensor. The system generates a reference
template from this fingerprint image.
Page 13 / 41